[landarts]

Wrapped a few more items so this can be started again and move in and out of the garage. Again went backward on a few items taking off, adjusting, and re-installing. The new radiator finally showed up and got that mounted fairly easy. Noticed that it had provisions for the transmission cooler which I don't need so I used one of my screw and bolt tools to identify the size of the plug thread and pitch. Went ahead and mounted it with freshly sandblasted radiator hold-downs. Will need to pull them off when painting the inner fenders since they are all getting the same semi-gloss.

Last item before I try to fire this up will be mounting the old tired exhaust system I pulled off. Will need it on there to drive down to local muffler shop and get the new installed.

_____________________________________________________________________

Mechanical Left
-Install new belts
-Install Alternator
-Install new mini torque starter
-Install fuel pump and gas line to carb
-Install new AC unit compressor and brackets
-Install wire harness
-Make new battery cables and a few 2-gauge ground wires with same materials
-Cleanup and replace terminal ends on electrical harness and repair where needed
-Install radiator and hoses
-Fabricate metal fuel line up to carburetor
-Screw down oil pressure fitting in rear of motor
-Wire distributor and electric choke on carburetor
-Hook up all electrical under hood
-Install power steering pump with new hydraulic line
-Install Shocks after painting and steering stabilizer
-Install old exhaust so I can drive it to get new exhaust or buy builder kit and DIY it
-Drop of spare 205 transfer case to have rebuilt and twin sticks installed

Body Work Left
-Front fenders - wet sanded to 1500 need buffing or repaint
-Finish last 15% body work on hood: prime and paint
-Finish passenger door 25% of body work: prime and paint
-Finish driver's door 40% of body work: prime and paint
-Finish last 25% body work on bed: prime, paint and Raptor bedliner
-Body work cowl: prime and paint
-Paint both front fender wells
-Paint all four new shocks from lift kit to match body
-Body work used tailgate: prime and paint
-Install new grill and lights

Interior items
-Finish painting AC and light switch plate made from glove box, also paint radio delete plate for heater control area
-Install new seat cover
-Install new flooring and sill plates
-Install 3-point seat belts
-Install new gauge bezel, dash pad and other new goodies