The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed

Arne · 12-10-2022, 04:10 PM

I looked into the Unisteer kit, but found that the kit (including the pump and brackets) is configured for short water pumps only. The pump mount may not work for you if you have long pump and pulleys.

I'm definitely going to pay attention to your solution. I have a POL rack on order, it should get here in a few weeks. I have a long water pump and the normal Saginaw pump, but will be using brackets from Alan Grove. I will need to check the U-joint clearance once I have it all here.

12-10-2022, 04:10 PM	#828
Arne Registered User Join Date: Sep 2022 Location: Eugene, OR Posts: 490	Re: Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed I looked into the Unisteer kit, but found that the kit (including the pump and brackets) is configured for short water pumps only. The pump mount may not work for you if you have long pump and pulleys. I'm definitely going to pay attention to your solution. I have a POL rack on order, it should get here in a few weeks. I have a long water pump and the normal Saginaw pump, but will be using brackets from Alan Grove. I will need to check the U-joint clearance once I have it all here. __________________ . - Arne Finished Project - 1964 C10 Stepside, mild restomod ———————————— Last edited by Arne; 12-10-2022 at 11:55 PM.