|
Re: HG's Dream Car Build - Shelby Cobra Kit
Made a little coupling from some roll bar tubing to finish the radiator hoses. The overflow tank didn't show up yet but I could at least start adding water/antifreeze. A gallon of each in it now but I'm going to pick up a flush kit to use the tee fitting with cap in the heater bypass hose. It's the highest point of the system, so I can finish adding coolant, possibly draw a vacuum to get air out.
Last night I went through the coyote install instructions regarding the harness. It talks about adding some wire in the O2 sensor feed to get length needed, but then just states to route the harness to reach the sensors. I started removing the wrap and got a little more room just with that, then started laying out the harness to see what needed to go where and think I have it sorted out enough. Most of the engine stuff is plugged in. I need to fab a mount for the ECU, then start tying the engine harness into the chassis/dash harness.
Not far from trying to start her up.
|