Quote:
Originally Posted by DBear
Good afternoon Richard...trying to revive this old thread LOL. I am about to do this same swap and wanted to know if you could tell me what depth did you drill the new bellhousing holes into the trans case? Thank you in advance sir.
Thomas
|
Hi Thomas,
Not Richard but check out my post #84. It explains what I did with mine. The secret is, if the hole is going to come out too close to the trans main case and force the bit off to the side, stop just as it starts to break through. All of the holes that weren't close to the case I drilled all the way through.
LockDoc
.