Re: "Upgrade" tail light sockets
I ordered a connector kit from amazon a while back when I did the harness for my LS swap, so i had tons of connectors leftover. I made one wire connectors for the ground, and 2 wire connectors for the taillight plugs. The reverse hot wire i soldered in the original plug and used that connector. I have a ground strip in the back that i used for my air ride relays, fuel pump, and just extra body grounds, so I connected the ground wires from the light sockets to this. If you dont have a ground strip, you can use any clean grounding surface you can find nearby.
__________________
67 1/2 ton Suburban - Project DRGNWGN. Build thread
-_--_--_ _________
_--_-_ -/____|__|__\__
,.,,,.,.,,.,|_O _______ O_]
Last edited by kev2809; 02-19-2023 at 07:10 PM.
|