The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**72tutone** · 04-25-2023, 07:14 PM

Passenger side and v8 hole location looks like? I will take a look again. I'm in the I6 spot. Apparently the further back it can go the better?

I would like to continue to use the slots as I already have a driveshaft made up. I just want to make sure they were accurate

If I use the mounts as you have them in the I6 slot, there is not alot of meat for the bottom bolt as its getting very close to the edge of the crossmember.

04-25-2023, 07:14 PM	#10
72tutone Senior Member Join Date: May 2010 Location: St.Louis Posts: 635	Re: Urgent question Passenger side and v8 hole location looks like? I will take a look again. I'm in the I6 spot. Apparently the further back it can go the better? I would like to continue to use the slots as I already have a driveshaft made up. I just want to make sure they were accurate If I use the mounts as you have them in the I6 slot, there is not alot of meat for the bottom bolt as its getting very close to the edge of the crossmember.