Could anyone with an inline 6 help?
Would anyone with a '63-'66 Chevy/GMC truck and an inline 6 take some measurements for me? I am installing a 292 in a '66 GMC with aftermarket frame/engine mounts and want to get it in roughly the factory placement, but the factory crossmember is gone. Even just sharing pictures would help a lot.
1. Distance from front of block to frame cross braces that the radiator sits on.
2. Distances from left and right frame to center of crank snout/harmonic balancer.
3. What degree should the engine be leaning back?
These will greatly help me install my 292.
Thanks!
|