Re: Rebuilding / Installing Hinge Pillar to Fender Seal
So the screws for this thing!
On the Chevy diagram where it says: ".152/.156 DIA # Holes In Plenum/Hinge Pillar" does that mean a diameter between 0.152 to 0.156 inch hole? I found various data sheets that point to a 0.15x hole for a #10 sheet metal screw in 18 gauge sheet metal...
Basically fussing on the proper size 5/16 Hex Sheet Metal Screw....
__________________
Richard
'72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT
SBC 350 | TH350 | LWB | AC | Buddy Seats
Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock
Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim
|