The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Rebuilding / Installing Hinge Pillar to Fender Seal

**Rich72C10** · 08-16-2023, 04:52 PM

Yep you did send those to me. I just don't see how the bracket fits flush around that lip to screw into the inner cowl on either side. Must be a optical illusion, compounded by me looking at my truck with the fenders on.

I even put my snake camera in there and can see two screws holes around the top hinge area and two screw holes below the bottom hinge area.

Basically I am looking into the door crack with the newly rebuilt seals in my hand and thinking how does it wrap around that lip I see and set correctly to be screwed down!

08-16-2023, 04:52 PM	#18
Rich72C10 Mr. Cheyenne Join Date: Jun 2020 Location: Kyle, Texas Posts: 1,644	Re: Rebuilding / Installing Hinge Pillar to Fender Seal Yep you did send those to me. I just don't see how the bracket fits flush around that lip to screw into the inner cowl on either side. Must be a optical illusion, compounded by me looking at my truck with the fenders on. I even put my snake camera in there and can see two screws holes around the top hinge area and two screw holes below the bottom hinge area. Basically I am looking into the door crack with the newly rebuilt seals in my hand and thinking how does it wrap around that lip I see and set correctly to be screwed down! __________________ Richard *'72 Chevy C10 Cheyenne Super WHT/MED BRONZE/WHT SBC 350 \| TH350 \| LWB \| AC \| Buddy Seats Upgrades:** Tilt \| Front Sway Bar \| Radio \| Sliding Window \| Bed Spare w/Lock Bed Rails \| Full LEDs \| Courtesy Lights \| Tachometer \| Glovebox Lock & Light \| Head Light Relays \| *Upgraded Fully Super Trim