Re: Rebuilding / Installing Hinge Pillar to Fender Seal
Got a good match for screws and a so-so "spacer" off Ebay. The spacer is slightly bigger but it will work well enough.
Amazon Prime - pack of 25 for $9.16 shipped
18-8 Stainless Steel Sheet Metal Screw, Black Oxide Finish, Hex Washer Head, Hex Drive, Type AB, #10-16 Thread Size, 1/2" Length
Ebay - Pack of 10 for $10.81 shipped
Specbolt M6x18 Shoulder Washer Motorcycle Plastics Collar Bushings- First photo the top screw/spacer are originals, then the bottom screw/spacer are parts listed above
- Second photo are some new ones and original staged on the seal.
- Third photo, there is one good hole on my original seals that I have and the "new" spacer sleeve fits snuggly - more or less like the original.
Personally, I think the hole stamping is a bit small on GMC Paul's Seal repos.
__________________
Richard
'72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT
SBC 350 | TH350 | LWB | AC | Buddy Seats
Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock
Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim
Last edited by Rich72C10; 08-18-2023 at 03:53 PM.
|