While I was up in Scotland visiting Bill, I managed to scavenge som plastic trim from a Mazda Bongo van he had chopped up.
Door lock and side needs trim.
This may be a plan.
Not quite a perfect fit, but a grinder, some heat gun action and we may have it looking a lot better.
During the week, while I travelled to Scotland, some anti-slip tape arrived at home.
So I removed the half-arsed attempt by some brain surgeon, leaned up many years worth of old hardened glue and proceeded to measure and cut.
Pretty messy and messed up.
Cut to length
Cut to shape.
Up close.
Liking that a lot.
Cleaned up the removable tow bar and removed the original license plate.
Fitted, with license plate in place.
Not ideal
And replaced the front license plate.
I am liking this.
Next job is to drill the holes for the retaining stip, carefully, in order to get the screws back in to hold the strip down.
Fit the rear license plate, as I had to clean up and repaint the rear plate support.