The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jaros44sr · 10-28-2023, 10:24 AM

Revisited wind windows

Bottom channel slid on with ease, liberal amounts of Windex

Holding between legs, and pulling with both hands, rear hand keeping pressure up to engage channel when you get this operation done, it will slide extremely easily, reapllications of windex is mandatory

The tool i used is a new panel separater, used to help guide the rubber gasket, CAREFUL this could cut rubber so polish end of tool

Revisited video several times

Now I have to get the vertical

16985023630998746133896727587967 by [url=https://www.flickr.com/photos/97391199@N06

10-28-2023, 10:24 AM	#3574
jaros44sr Registered User Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,430	Re: PO has me PO'd Revisited wind windows Bottom channel slid on with ease, liberal amounts of Windex Holding between legs, and pulling with both hands, rear hand keeping pressure up to engage channel when you get this operation done, it will slide extremely easily, reapllications of windex is mandatory The tool i used is a new panel separater, used to help guide the rubber gasket, CAREFUL this could cut rubber so polish end of tool Revisited video several times Now I have to get the vertical 16985023630998746133896727587967 by [url=https://www.flickr.com/photos/97391199@N06 __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 10-28-2023 at 10:30 AM.