The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Rebuilding / Installing Hinge Pillar to Fender Seal

**Rich72C10** · 11-25-2023, 09:53 AM

Thanks Greg and for your help & photos you send it. Other than some stripped out original holes for the seal, I didn't run into any problems figuring it out.

It is interesting on the foam seal, where you stable it to the bracket, also has those two screws. I suppose Chevy really wanted them to stay on the bracket.

11-25-2023, 09:53 AM	#33
Rich72C10 Mr. Cheyenne Join Date: Jun 2020 Location: Kyle, Texas Posts: 1,644	Re: Rebuilding / Installing Hinge Pillar to Fender Seal Thanks Greg and for your help & photos you send it. Other than some stripped out original holes for the seal, I didn't run into any problems figuring it out. It is interesting on the foam seal, where you stable it to the bracket, also has those two screws. I suppose Chevy really wanted them to stay on the bracket. __________________ Richard *'72 Chevy C10 Cheyenne Super WHT/MED BRONZE/WHT SBC 350 \| TH350 \| LWB \| AC \| Buddy Seats Upgrades:** Tilt \| Front Sway Bar \| Radio \| Sliding Window \| Bed Spare w/Lock Bed Rails \| Full LEDs \| Courtesy Lights \| Tachometer \| Glovebox Lock & Light \| Head Light Relays \| *Upgraded Fully Super Trim