The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Rich72C10** · 12-03-2023, 03:20 PM

Do you have to use the red one? No you don't. At some point you'll care after driving enough times at night! You can get the Black or Red with the light bulb, which is the one that is designed for a tilt column. I would think the one you see on Amazon is for the Non-Tilt Column version with the light fiber line to the cluster dash lights.

But if you get the Red one again, I am nearly 100% sure you need to remove the bezel - be sure to look at that thread I put in my previous reply. I think the reason is: you can't remove the red pull, like you can the black one.

It is all up to you which direction to go but the Red on can be installed (but it can be a PITA to get the Bezel off).

12-03-2023, 03:20 PM	#5
Rich72C10 Mr. Cheyenne Join Date: Jun 2020 Location: Kyle, Texas Posts: 1,644	Re: Turn signal switch doesn't fit. Do you have to use the red one? No you don't. At some point you'll care after driving enough times at night! You can get the Black or Red with the light bulb, which is the one that is designed for a tilt column. I would think the one you see on Amazon is for the Non-Tilt Column version with the light fiber line to the cluster dash lights. But if you get the Red one again, I am nearly 100% sure you need to remove the bezel - be sure to look at that thread I put in my previous reply. I think the reason is: you can't remove the red pull, like you can the black one. It is all up to you which direction to go but the Red on can be installed (but it can be a PITA to get the Bezel off). __________________ Richard *'72 Chevy C10 Cheyenne Super WHT/MED BRONZE/WHT SBC 350 \| TH350 \| LWB \| AC \| Buddy Seats Upgrades:** Tilt \| Front Sway Bar \| Radio \| Sliding Window \| Bed Spare w/Lock Bed Rails \| Full LEDs \| Courtesy Lights \| Tachometer \| Glovebox Lock & Light \| Head Light Relays \| *Upgraded Fully Super Trim