[bhap]

It has been a while since I fixed mine, but I think the screw that holds the turn signal lever should be centered in the hole when the signal is off. I would loosen the cable at the bottom of the steering column - which is where the electric happens - and the adjust the cancel mechanism and column housing so that it lines up the screw with the opening for the lever when the detents are in the middle. Tighten up the top then go to cable and switch at bottom of column. Put switch in center position and tighten. As long as you have the springs in place and the cable/stiff wire is free to move along the column, it should work. I think I added a couple of cable ties along the wire so it didn’t flex when the signal was activated.