The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - LockDoc's "Low Budget", "Low Maintenance" Project Thread

**Sheepdip** · 01-28-2024, 12:14 PM

I used an 86 cradle assembly on mine the spindle and rotor components, not the cradle itself, the front springs were about 1-1/2 to 2" taller, I reused my original springs as I did not want to change the ride height.

I'm assuming it may have raised it more than 2" as I found out when buying rotor pads it was considered "Heavy Duty" front end.

01-28-2024, 12:14 PM	#490
Sheepdip Senior Member Join Date: Nov 2018 Location: Waterford California Posts: 2,403	Re: LockDoc's "Low Budget", "Low Maintenance" Project Thread I used an 86 cradle assembly on mine the spindle and rotor components, not the cradle itself, the front springs were about 1-1/2 to 2" taller, I reused my original springs as I did not want to change the ride height. I'm assuming it may have raised it more than 2" as I found out when buying rotor pads it was considered "Heavy Duty" front end.