I just acquired one of these tanks at a Swap meet last weekend.
Reason for this is a story in itself.
So, the tank I have is rusted beyond putting back in service.
The pattern is there for the Dimensions to fabricate a New one.
I acquired it to possible Machine the tank nuts on the bottom.
Then I searched the forum a Guy from Washington State is making them cheaper than I can get the material for them.
I still plan to make a set or 2.
I have a Question.
Are these Spacers in your Picture?
(That I circle these in blue.)
If so do you have the dimension for them?
If you can share that, That would be Great.
Thanks for sharing your Knowledge on these Tanks.
This picture below is the nut I have for a Pattern.
In the Blue circles, Are those Spacers?
