Another day, another challenge! Well it would appear that my initial exuberance
about the headers fitting might have been a bit pre-mature.
the passengers side is great. The drivers side sits so close to the bell housing that, it touches the clutch fork. So, I have ordered a couple header flanges and am going to try and space it out. if that doesn't work then i will try a different set of headers.
I painted up my ECM bracket and it's ready to go in the cab.
I also got my driveshafts in from the drivetrain guys. Front was shortened and rear was lengthened.
Today, more plumbing. Any header suggestions would be great. I realize that if i don't get these to work then i am probably looking at 3/4 length headers.