Quote:
Originally Posted by SCOTI
Yes & yes. But the limits I see on the Speedway Engineering site indicate 1.250" OD solid bars when desiring a 32" bar width. They show larger bars for 'cup' cars but @ 37" widths which is too wide for me.
I also didn't want to be 1K into a front sway bar & haven't seen any pricing yet.
|
Take a look at Kartek's site. They have the Speedway Engineering bars in solid, 0.188, and 0.250 wall in lenghts from 32" up to 39.5 in one inch increments.
$150 for the bar is about as cheap as your going to get for a quality product. They have a fair selection of arms as well including some blank aluminum bars you could have machined with some detail if you desired.
Capture by
Wyatt Lassiter, on Flickr