Re: Project "Financial Burden": 1968 SWB C10
I've been working on the small things lately. I converted my three speed on the column to a floor shift setup with the correct collar. During disassembly of the column, I found damaged threads on the steering column nut. I didn't want to scrap the shaft so I repaired the damaged threads by sizing it down from 1/2-20 to 7/16-20. I also plumbed the gas tank vent/roll over valve (hope I don't need that!). It was a little tricky since the gas tank fill is in the bed floor so the vent is elevated above the floor and nest within the bedside.
|