Re: No Limit Trailing Arm Rear Suspension
There is only one hole left to drill. This is for the panhard bracket brace. To get the roll center low, really low, compared to a stock or modified C10, the mounting brackets have to drop down pretty far. Even though the new Low Roll mount is made from 1/4" steel, it would bend in an instant if not supported. The support rod is 1" in diameter and uses 1/2" heim ends. They are both RH thread. Simply assemble the bar with 3/8" of thread exposed on the rod ends, and bolt it into the new Low Roll bracket. The other end will bolt to the bottom of the crossmember. Use the brace rod to locate and drill the 1/2" hole. Bolt in the brace rod.
__________________
GoodGuys 2012 Pro-Truck Champion
2012 Truckin' Throwdown Champion
GoodGuys 2011 National Champion
2011 Truckin' Throwdown Champion
GoodGuys 2010 National Champion
Proud to put our products up against all others!
|