View Single Post
Old 02-16-2016, 08:55 PM   #18
Tom
driving is in my blood
 
Tom's Avatar
 
Join Date: Dec 1999
Location: Mesa AZ
Posts: 5,687
Re: 1 pc rear main v 2 pc rear main

Quote:
Originally Posted by LookSlowGoFast View Post
factory roller block w/4 bolt mains
fully machined and .030 over
Eagle rotating assembly w/hypereutectic pistons 9.5:1 w/76cc heads, 3.75 stroke cast crank, forged 5.7in rods
EQ Torker heads w/2.02 in 1.6 ex, 76cc cnc'd chambers, and I believe 190cc runners, but may be wrong on that one
Stainless roller rockers 1.6
Holley Street Dominator dual plane intake
HEI distributor
th350 trans

I plan to keep it under 6,000 rpm with a rev limiter.
This seems like a mis-match to me. Going for 76cc heads and pistons to make those work limits your ability to use any other performance head as they are all 64cc and for good reason which is chamber shape and efficiency. Even GM went to 64cc's stock after '95. If possible I'd go with 64cc heads and matching pistons to get 9.5:1.

Speaking of heads, you want to run 190cc ports with only 383cubes and a 6000rpm max? You want 180cc at best, or run the engine higher up.
__________________
-78 c10 short/step: 388cid, M20, 5/5 drop, lots more. Playtoy and first vehicle.
-98 c1500 x-cab: 5.7L, 17" rims, 5/6 drop, flowmaster, helper bags,NBS rear disk brakes.
-02 Suburban 4x4: leveled front
-CBR600F4i, CBR600RR, CBR1000RR, and standup skis
DISCLAIMER: I cant spell for the life of me.
Tom is offline   Reply With Quote