|
Re: Project: Recycle
Quote:
Originally Posted by lolife99
It's just carbon steel.
I was going to have a buddy tack weld it in place from the bottom,...
and then finish weld it from the top.
I wanted something thicker than sheet metal, so I could tap the holes and use stainless machine screws instead of sheet metal screws.
|
Similar plan here. I'll use a steel backing plate w/SS machine screws to secure the filler in place.
I actually considered doing a little from each of my choices from the previous pics (weld in a flat piece of steel across multiple floor runners beveling the edges between to match the factory & simply mount the filler in the center).
I figured if my 1st attempt didn't work out, it's simply a matter of cutting it out @ welding in the flat piece.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 03-02-2010 at 01:43 AM.
|