The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed

88Stanger · 10-26-2020, 05:37 PM

Update:
So i got the replacement panels for the entire passenger side door area and floor in. Floor is almost fully welded in, along with the pillar area, then after door install check was good i was Spot welding in the bottom outside door panel and well out of gas for the welder i go.... damnit.... lol

10-26-2020, 05:37 PM	#328
88Stanger Registered User Join Date: Mar 2015 Location: Washington State Posts: 1,644	Re: Starting 1966 Factory Short Bed Build, Bagged, 383 Stroker and Muncie M20 4-Speed Update: So i got the replacement panels for the entire passenger side door area and floor in. Floor is almost fully welded in, along with the pillar area, then after door install check was good i was Spot welding in the bottom outside door panel and well out of gas for the welder i go.... damnit.... lol