|
Re: Z06 Corvette Exhaust Manifolds
Quote:
Originally Posted by BigRed76
If you use a motor mount setup like this, that uses adapter plates to put the motor mounts in the stock SBC location, then these manifolds would work.
|
One thing to think about is clearance around the heads, @ the firewall....that engine is set in 1" forward from the I 6 position. However, the firewall was clearanced for a BB Olds that was run in the mid 90's (it fits pretty tight at the rear). To move the engine forward much at all , may cause problems on the bottom for clearance on the pipes/cats ? Longhorn
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|