|
Re: Trailing arm crossmember with No Limit Arms
Quote:
Originally Posted by Joyridin
Ok. I am not sure if anybody else had a problem, but they must have some problems because they sent me repair parts free, but the bushings on my lower front control arms both times did not make it past 1500 miles. Both times, the alignment shop couldn't align the truck because there was too much play in the lower bushings. I had new ones made out of D75 Polyurethane. Not Delrin. They are holding up well now. Just an FYI. I was a PITA to rip everything apart and replace them.
https://www.grainger.com/category/ra...&filters=attrs |
Thanks for the heads up! When did you buy your kit &have the failure? I'll look into your solution and see about making some up ahead of install.
__________________
71 c-10 Long Bed, under the knife for a No Limit Engineering Wide Ride Chassis Pack and coil over static drop.
07 Silverado Classic 2wd
95 Camaro 427SBC/TH350
|