[88Stanger]

Originally Posted by SkinnyG

I patched a section of the Toe board, as it was far more pitted than i wanted. The passenger side inner rocker and cab supports got installed, and now that all that structure is back in and located, the A pillar bottom and kick is being replaced. I was a horrible judge of how long this would take. OMG.

SkinnyG - How are the lower flat part of the that inner cab floor-door panel as they fit to the outside panel you then put on? I used 2 halves for the cab floor and they do not match in length at all. The rear section is close but the front is way too short. I will also need to push it towards the outside of the cab to meet the outside door panel to spot weld. This is the part that is on the very bottom of the door/floor section below the door.