[darrellyates]

Use the search above for floor repair or floor replacement. Any competent body shop can replace the floor in your truck. I had the entire floor in my truck replaced, as after sandblasting the bottom basically was full of small holes. I'll try to post a couple of pictures. I just did this with a Camaro as well. You have to cross brace the cab, then drill all the spot welds out, then it basically drops out. Of course, you have to have the cab off of the frame for this, so you must tear it down completely.

I've seen posts on here where people do it one side at a time, and leave it on the frame, but I don't see how that saves any time or money. Plus, when you buy a full floor, it comes with all the mounts and bracing pre-installed, so everything is new once you put it in.

After raising into position re-drill all the holes and spot or plug weld it back together then seam seal everything, and you are ready to scuff, prime and paint.

It's a big job, but really nice to have everything solid again.

Good Luck. Will try to post a couple of pictures...