The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

1964C10 · 06-10-2009, 08:21 PM

Thanks Protrash!! I didn't look to see if the clamping it offsets it but that is a good point. At the moment I only have 6 to do so I dont mind spending a little extra time getting it right. What do you use after you use a tube cutter to debur the inside? I have read on here to use a drill but then it leaves like a sharp edge which I then file but I think that might be causing a little bit of crooked edge(?)

06-10-2009, 08:21 PM	#13
1964C10 Registered User Join Date: Mar 2008 Location: San Marcos, CA Posts: 578	Re: Brake line flares, what's good enough Thanks Protrash!! I didn't look to see if the clamping it offsets it but that is a good point. At the moment I only have 6 to do so I dont mind spending a little extra time getting it right. What do you use after you use a tube cutter to debur the inside? I have read on here to use a drill but then it leaves like a sharp edge which I then file but I think that might be causing a little bit of crooked edge(?) __________________ 1964 Fleetside LWB 1995 Yellow Mustang convertible 1996 Camaro Z28 My build thread Looking for help on completing the Disc Brake Upgrade Reference Thread If you didn't build it, you don't really own it