Re: 350 piston ht.
Easy to measure deck clearance on an assembled motor, I misunderstood what stage fo the build you were at. Bridge the bore with a good straight-edge and measure clearance from top of piston to bridge with feeler gauges. Easy-peasy
Measure at the piston PIN centerline so piston rock doesn't influence the measurement. The balancer "0" mark is probably close enough for TDC unless you suspect it has slipped. If you have a mag-mount dial indicator no better time to check the timing tab really IS 0
__________________
Still playin with trucks, even at my age!
When you're dead, it's only a problem for the people around you, because you don't know you're dead.
.....It's kinda the same when your STUPID.
I just did my taxes and reviewed my SS statement. Thanks to the current administration it looks like I will only have to work till noon on the day of my funeral.
|