|
I have a lm4 aluminum block so I had to drill a hole for the dipstick. When I tried to remove the mounting tab I ripped a big hole in the side of it. So I bent, cut center section out, welded back together with a shorter tab for a cleaner low profile look. I also shortened about a foot out of the trans dipstick. I also made this bracket to mount pcm, Tac Module, obd2 and 2 fuse blocks. Eventually I want all wiring coming out of this spot and having drivers side less cluttered. I wanted it under dash but all together with room for vintage air heater/defrost. I’m going to paint it black tomorrow since it hangs below dash.
Posted via Mobile Device
|