[MCB Matt]

Originally Posted by everettelane

Here is a pic of what i'm talking about, i know i can find some fittings to rotate it, do not have other places to move the sensor to, it's an lt1 just saying if there was a 90 degree plug it would save some people the aggravation of finding other fittings if you notice in the pic the original one wire plug has no problem with clearance of the header. i'm sure most people just go find other fittings and go on about there business but you would figure after spending 1300 bucks this would not be a problem, Thanks!!!

Do you have a pic of the top of the motor, near the water neck? This has never been brought up before. What headers are you running? The new sensor is a 2 wire and the connector they use is actually a very high quality piece, especially when you compare it to that stock one.

Thanks
Matt