The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

1955GMC · 01-22-2013, 02:53 PM

I have installed the 1985 Corvette F & R suspension using Flat Out Engineering install kits. I have bought 5.3 engine, transmission and ECM with 13,987 miles out of a ’03 Tahoe, with a CarFax report! I have an Old Air Products air conditioner that fits the ’55 GMC dash.
I have bought a PSI engine harness and a Kwik Wire harness for the cab and chassis.
My old dash had been butchered by the last owner. It had one of those Cadillac Wonder Bar radios direct in the center. This change eliminated the ash tray, heater controls and original radio slot. I really like the ’55 2nd series dash so I looked for about 2 years for a new dash. Found one on E-Bay

01-22-2013, 02:53 PM	#3
1955GMC Registered User Join Date: Sep 2012 Location: Surgoinsville tn Posts: 22	Re: My 55 GMC Build I have installed the 1985 Corvette F & R suspension using Flat Out Engineering install kits. I have bought 5.3 engine, transmission and ECM with 13,987 miles out of a ’03 Tahoe, with a CarFax report! I have an Old Air Products air conditioner that fits the ’55 GMC dash. I have bought a PSI engine harness and a Kwik Wire harness for the cab and chassis. My old dash had been butchered by the last owner. It had one of those Cadillac Wonder Bar radios direct in the center. This change eliminated the ash tray, heater controls and original radio slot. I really like the ’55 2nd series dash so I looked for about 2 years for a new dash. Found one on E-Bay Attached Images Last edited by 1955GMC; 01-22-2013 at 02:59 PM.