Hey, thanks 86. It was a little confusing (I'm still on the apprentice side of serious motor work) but it gives me a good idea. I'm not too worried about pulling the motor because I have to pull the 327 out of my C-20 to put it into my C-10. So since I'll have it out I figured that I would have some work done to it. I also have a running, pulled 350 in the garage. I was thinking about putting that in the C-10 instead since it is already out but that one runs kinda rough and would probably need quite a bit more work. At this time I'm thinking of taking the less expensive way out, so I will probably shelve the 350 for now. Sorry, just thinking out loud