The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Home-Made Speaker Kick Panels

Frizzle Fry · 03-07-2007, 05:27 PM

The panels are held in place by the air-vent puller brackets, a tight fit around the floor and dash edges, and one sheet metal screw on each side. Those screws are located right behind the speakers as far down and back (toward the door) as I could reach. I considered using a hot glue gun to mount them, but decided one extra screw hole on each side was acceptable (the PO already put several on each side anyway…).

Now I just need some carpet...

03-07-2007, 05:27 PM	#7
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: Home-Made Speaker Kick Panels The panels are held in place by the air-vent puller brackets, a tight fit around the floor and dash edges, and one sheet metal screw on each side. Those screws are located right behind the speakers as far down and back (toward the door) as I could reach. I considered using a hot glue gun to mount them, but decided one extra screw hole on each side was acceptable (the PO already put several on each side anyway…). Now I just need some carpet...