[TA_C10]

Started working on cab. You can see my previous work on the driver side floor pan repair. Now I am working on finishing that up and all the other work that needs to be done.

Here i'm working on the passenger side floor pan repairs. I used my same method of marking lines on the panel as a stopping point each section I was grinding till it was all just the way I wanted it. Takes a while but the outcome was good.


Here is the fit just before I started tack welding.









And here we go, starting to tack her in. My welding skills are getting a little better after changing the polarity on the welder and getting her dialed in from the hood work.












And here it is all burned in.










Didn't get any pics of the next big panel but you can see it ground down in the following pics. And I have pics of the crazy little zig zag pieces I burned in and finished the passenger side floor.
















You can see how I started my tacks, hammered the piece into position, tacked a little more, formed the piece, tacked, formed, etc.