Quote:
Originally Posted by B. W.
I agree also, repair the rust, no need to remove the inner roof panel. I just did this repair, before I put the new roof on (after primer) I sprayed cavity wax down the A & B pillars and along the rear of the cab. the driver's A pillar has an access hole already, I drilled a hole for the passenger side.
|
B.W., Did you remove the corner support at any time during your restoration (area circled in red in photo below)? I would like to remove the corner supports so I can clean underneath them. It looks like I would have to make a cut (see green line in image) to avoid taking the entire length out and drill out some spot welds on the outer edge, but I am not sure if the inner edger (see red arrow in photo) is welded or adhered in any way. Thanks.