The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - PROJECT "Father/Son" C-20 Rolling Chassis Build

**ChiefRocka** · 11-08-2007, 09:06 AM

-
-
I needed to use one of the plugged ports on the tank for fill...so what I did is drilled a hole thru the chassis, and used a Parker (of course) swivel 90. Other wise I would of had to use a Tee fitting at another port....not so clean.
-

-

-
Valve mounting:
-

11-08-2007, 09:06 AM	#111
ChiefRocka Hollister, CA. Join Date: Sep 2006 Location: Hollister, Ca. Posts: 6,147	Re: PROJECT "Father/Son" C-20 Rolling Chassis Build - - I needed to use one of the plugged ports on the tank for fill...so what I did is drilled a hole thru the chassis, and used a Parker (of course) swivel 90. Other wise I would of had to use a Tee fitting at another port....not so clean. - - - - - - - - Valve mounting: - __________________ John What the Heck is that ?? CURRENT BUILDS: 62 BurbMaster Other Builds: My '63 C-10,LWB,CC,BBW '06 HD StrAight Axle Swap Father/Son '67 C-20, LQ9,4L80,Bagged,8-Lugger !!Good Friend Richard's Build AMERICAN CUSTOMS & CLASSICS (831) 630-1965 www.ACCHOLLISTER.com ACC on FACEBOOK "Rest in Peace, Mom & Dad ... I will see you again someday!" Last edited by ChiefRocka; 11-08-2007 at 09:14 AM.