I'm so annoyed at the vent window rubber and seal I got. The latch has a good quarter inch hang over and wont latch. I could cut a thin strip along the edge of the seal to make it fit, but how annoying... And the rivets are so hard to get to I haven't got one to be accurate. Note, if you do these make sure you are on a good solid surface, like a concrete floor. A wood table bounces to much and is much more work on the rivet. I will have to drill them out and get some "pop rivets" that I have read about. They will be much easier to get in that tight corner.
I feel better now, thanks for listening. lol
Photo of the painted valve cover.