[landarts]

Bought these at the local pick-a-part a few years ago for $10 each. They were in good shape, each of them had an extra hole where the previous owner added an additional screw. Also one panel had a very small burn/melt flaw where someone probably drop a cigarette and burned it.

I scrubbed them both down with a 1/1 mixture of hot water and simple green and a hard bristle carpet brush. Wiped them down with grease and wax remover and they looked splotching from the chemical. So I did another round of Simple Green and hot water. After they dried they looked much better so I spray down the areas for repair with a coat of SEM plastic adhesion promoter let that flash and then a few coats of SEM texture spray. Before the texture was dry I blotted it with a wrinkled up piece of saran wrap to simulate the existing texture for the repair area which was only about 1/4 of inch square. Next after the texture dried I sprayed both panels with SEM adhesion promoter and let it flash. Followed by three coats of SEM color coat.

I am very happy how they turned out and will be installing in the next couple of days. SEM products have it down to a science and make it look like new again. I am a big fan of there system. First picture is the before picture and second of he completed process.