Quote:
Originally Posted by nlped
Hey Keith,
Any recommendation or insight on which balljoint is the "smaller" shaft upper & lower ball joints so I can throw them in an extra set of control arms that I have, so I can bolt all of the spindles in place on the same BJ. I figure even if they're a little small, it won't affect the measurement as long as it's tightened down...right? Any certain generation control arms that I should use? I probably have them all  |
I just saw this.
The 63-70 ball joints have the smallest taper.
I don't think it matters on the a-arms.
67-72 or 73-87 should be the same physical dimensions.