[Just-in-credible]

Hello,

Wondering if anyone out there has any experience in wiring the Nv246?

I am in the middle of a frame swap of a 1960 Apache onto a 2006 Tahoe frame, and the last thing I need to get working is the transfer case.

I took l of the wiring harnesses from the Tahoe, and I tried connecting them on the Apache, and it’s like the transfer case control module is dead. There should be life at the switch, and the indicator lights do not come on.

I had 4wd before I took the Tahoe apart. I thought this would be fairly simple. Power to the couple orange wires that power the TCCM, and the brown wires that power the front axle actuator. I tried some trouble shooting, and I do have the front axle hooked up correctly. When I ground the correct pin, the front axle actuator does its thing.

I just can’t figure out why I don’t have any life at the TCCM. It seems like it doesn’t have a power or ground hooked up correctly, but I double checked all of them.

Thoughts?

Any help would be appreciated.