Ugh...I already don't like Flickr.
OK, maybe this will work!
Below is a pick of the driver's side wiring. I think I have it right here except for the little guy at about 1 O'Clock. Does this connection bolt to the nut pressed into the core support? I have it pulled up into the nut with a copper wire.
(I think it must go there as it seems like it wants to and has the impression of a nut on one side).
https://www.flickr.com/photos/152442...posted-public/
Next is the "Junction Block." I think I have this attached to the fender correctly.
https://www.flickr.com/photos/152442...posted-public/
Next is the ground wire that goes to the core support behind battery tray (passenger side). Is there where this goes?
https://www.flickr.com/photos/152442...posted-public/
https://www.flickr.com/photos/152442...posted-public/
Here comes the fun. The cable with the blue tape is the positive and runs to the starter motor. It also has a wire that attaches to the Junction Block.
https://www.flickr.com/photos/152442...posted-public/
The pic I tried to get of my negative cable and its attached grounding wire turned out very blurry so I didn't include it. Here is a shot of where both battery cables go. Negative is attached to the engine but where does the smaller wire go? (Smaller wire is attached to the negative cable at the battery terminal end. Mine has yellow overspray on it so I assume it was near the fender from factory and when truck was painted in 1990).
In this pic the "smaller wire" from the paragraph above is looped into the cable end just to get it out of the way. Where does the "smaller wire" attach?
https://www.flickr.com/photos/152442...posted-public/