[childerskustoms]

alrighty, first post of ideas and such.

Whats been going trough my head as of late is the suspension, since ill be removing the 4x4 aspect of the truck ill need to move torwards an independent front suspension of sorts. thats where the 2wd comes in. i can take the upper and lower control arms, mounts and put them on the 4x4 frame. eliminating the torsion bar setup as well is something im going to do since id like to modernize it as well. id be welding on a lower coilover mount to the lower control arm of the luv and making an upper mount from scratch. making sure to make it fit with the inner fender without too much problem. id also be switching the manual steering gearbox to a power steering rack to give more control for people that didnt grow up with manual steering like myself. Since i am putting a 350 sbc from a mid 70s suburban ill have to take the old 4 cylinder engine mounts out and install new ones in good locations for the 350 to sit with just enough room for everything else in the engine bay. moving back on the frame, i will be removing the trans mount for the old 4 speed so i can sell it to anyone looking for a decent one for their project along with the front diff, axle shafts, and hubs for anyone needing them. since i will be putting a saginaw 3 speed from a early 70s nova in its place i am going to fab up a removable trans mount to make ease of access to fix of replace the 3 speed easier. moving further back along the frame, ill be relocating the fuel tank to the back of the frame mainly to make room for the 4 link setup ill be fabricating and designing. the frame will need support for the front mounts of the 4 link so i will be makikg a front brace to be able to weld the upper link mounts to. ill move the shock mount brace to behind the rear axle and make mounts for coilovers for the adjustable shocks. and the fule tank will fit just behind that