[Mattman2010]

Friday I got the rear drive shaft cut down, i also ordered some new rear ubolts so I can get the rear axle fully installed. Droping the Transmission 2 inches and the carrier bearing 2.5 inches did the trick of fixing all of my angles in the drive line. I removed the 6.2/SM465/NP205 for hopefully the last time! I got the tranny/tcase ready to paint. I need to install new front steel lines and mount the engine cross member and then the drive train will be ready to go back in. I need to get the gas out of the tanks and clean and paint them and then finish up a few things on the frame and then it will be time for body!

I am having a hard time finding ujoint straps for my dana 44, I took the dana 44 out of my k20 about 3 months ago and have lost my straps and its hard to find some new ones.