Dakota Digital VHX and turn signals
I'm installing the VHX kit with BIM module....all wired up...so I am using the little plug-in turn signal connectors they supply to put the blinkers in the stock location of the dash, I tied them to the DK blue and Lt blue wires from the original cluster connector.
when I turn the key on, both arrows are lit up, and stay that way all the time. I do not have the front light harness hooked up yet, just wires hanging there up front till I finish assembling the front end.
anyone done this before, and am I missing anything by using those cluster connector wires that I pulled from ? Is the reason they are lit constantly due to not having the front harness/bulbs/grounds connected up ?
thanks in advance
__________________
71 C10 long bed, 2003 6.0L, 06GTO E40, T56, 12bolt 4.10 rear
|