Also got the exhaust from the cab back fabricated. Ill finish the front half once the motor/headers are installed.
Got a rear sway bar from Performance Online. Might have to shorten up the end links a little more as they hang down a little further than i like
Been trying to figure out a way to utilize the forward pedal pivot point and i think i got it. Used a second set of pedals and some rod ends to connect the two. The master cylinder push rods still connect in the original location so there are no issues with angle or arch. I can move the rod ends up or down to manipulate the pedal ratio to dial it in once i get it on the road. Pedals are now lower and push more towards the floor not the firewall