The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MONTE · 01-15-2019, 11:31 PM

Finally moving on the Cummins.
Found a Getrag transmission to go with it.
Got it running on a stand after a few rounds.
Was going to put it in a suburban I found in Portland, Oregon but the guy backed out. Saved me a 2400 mile roadtrip. So the search continues for a c20 suburban.
Injectors keep leaking from the top bolt. I’m going to remove the injectors/clean and torque back to specs, hopefully that fixes the leak.
I’ll try to post a video of it running.
This is what I’ve done:
KDP fixed
New front housing
New vacuum pump
Water pump
Gasket replacements
Thermostat
Crush washers
Oil line for vacuum pump
Throttle rod
Just ordered the fuel pin and 3200 spring from the hungry diesel.

01-15-2019, 11:31 PM	#21
MONTE Registered User Join Date: Oct 2005 Location: Donna, Texas Posts: 286	Re: C20/cummins 12 valve Finally moving on the Cummins. Found a Getrag transmission to go with it. Got it running on a stand after a few rounds. Was going to put it in a suburban I found in Portland, Oregon but the guy backed out. Saved me a 2400 mile roadtrip. So the search continues for a c20 suburban. Injectors keep leaking from the top bolt. I’m going to remove the injectors/clean and torque back to specs, hopefully that fixes the leak. I’ll try to post a video of it running. This is what I’ve done: KDP fixed New front housing New vacuum pump Water pump Gasket replacements Thermostat Crush washers Oil line for vacuum pump Throttle rod Just ordered the fuel pin and 3200 spring from the hungry diesel. Attached Images Last edited by MONTE; 01-16-2019 at 01:33 AM.