Re: Horrible Paint job, and how to proceed?
No pics attached. However, best to sand it down with some 120 grit and feather it out until you have a relatively smooth surface. Spray it a with a few coats of self etching epoxy primer, which will seal the surface so no reactions happen. Sand again with some 220 to level out the primer. Fog it with a contrasting primer, then sand with some 320 grit. This will show you the areas that need special attention. Once you have it all happy with the 320, spray your single stage and then wet sand from there. Watch your edges and always sand with a block to keep a flat sanding pad.
|