The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project~”

Grizz1963 · 11-03-2018, 06:01 PM

Sharpie in hand, time to trace the patch panel out.

While all this was going on, Security cat had decided to get comfy, on the job.

First welding job was to do then30mm upright for the side kick panel, they rust out in the bottom corner and you need to replace that steel too.

Easier to weld in some metal, than another fold, if your steel is not that wide.

Technically the outside, and awaiting weld through primer before it all gets welded in.

Inside

And in place.

I will probably only cut the floor and weld this in by next weekend.

Unless I get time, which is unlikely as it’s another week from a dark place.

Later.

[quote author="@shielsy68" source="/post/2452958/thread" timestamp="1539042120"][img src="http://img.retro-rides.org/i/v/shielsy68/b6b28177be48.jpg"]

i was bought a pair

[/quote]

11-03-2018, 06:01 PM	#6
Grizz1963 Registered User Join Date: Dec 2012 Location: Rochester, KENT Posts: 10,465	Re: GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project Sharpie in hand, time to trace the patch panel out. While all this was going on, Security cat had decided to get comfy, on the job. First welding job was to do then30mm upright for the side kick panel, they rust out in the bottom corner and you need to replace that steel too. Easier to weld in some metal, than another fold, if your steel is not that wide. Technically the outside, and awaiting weld through primer before it all gets welded in. Inside And in place. I will probably only cut the floor and weld this in by next weekend. Unless I get time, which is unlikely as it’s another week from a dark place. Later. [quote author="@shielsy68" source="/post/2452958/thread" timestamp="1539042120"][img src="http://img.retro-rides.org/i/v/shielsy68/b6b28177be48.jpg"] i was bought a pair [/quote] __________________ MY BUILD LINK: http://67-72chevytrucks.com/vboard/s...585901]Redneck Express - 1966 C10 Short Fleetside MY USA ROADTRIPS http://forum.retro-rides.org/thread/...2018-humdinger IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM MATE.